yield strength

yield strength什么意思,yield strength翻译

基本解释

un.: 〔物〕屈服强度

英汉解释

• 〔物〕屈服强度

例句

• The largest value being that of the ultimate strength. Not every area of the cross-section will have exceeded the yield strength.

  在最大程度上利用了材料的强度，并不是截面的每一处都已经超出了屈服强度。

• The change at the elastic limit from elastic to plastic deformation is referred to as the yield point or yield strength.

  在弹性极限范围由弹性变形到塑性变的变化叫作屈服点或屈服力。

• Determination of the yield strength of nuclear reactor pressure vessel steels by means of amplitude-dependent internal friction.

  通过随振幅变化而变化的内磨擦测定核反应堆压力容器钢屈服强度…[中国核科技信息与经济研究院]。

• In general, yield strength increased with a reduction in heat input in agreement with what was observed for hardness.

  大体上，生产量力量以为坚硬被观察在协议在热输入中有减少增加。

• The yield strength, tensile strength and impact toughness of the material after iron plated do not obviously reduce.

  镀铁后材料的屈服强度、拉强度和冲击韧性值未发生明显下降。

• The results indicate that the oxido- decarbonisation on the surface makes the static bending yield strength decrease by 15%.

  结果表明，表面层的氧化脱碳使静弯屈服强度降低15%左右；

• the higher the initial relative density, the lower the yield strength of the material, and the earlier the time of break occurred.

  初始相对密度越大，材料屈服强度越低，出现破裂的时间越早。

• Tensile and yield strength are determined by pulling a standardized machined sample in an tensile testing machine until the sample breaks.

  抗拉强度和屈服强度的测定是在拉力试验机中将一个加工好的标准试样进行拉伸直至试样断裂。

• Oxgen precipitates (useful for gettering ) can reduce the yield strength (critical shear stress) up to fivefold.

  氧沉淀（可用作吸杂）会使屈服强度（临界剪应力）降低为五分之一。

• The mechanical property testing showed that the yield strength is too high and the elongation rate is less than the technical requirements.

  随炉试样力学性能测试结果表明，屈服强度较高，伸长率偏低，无法满足该零件技术要求。