求华为EC1261无线网卡如何运行

共有 1 条评论

1. 鱼头_火锅 于 2010-02-22 20:37:41发表:

   首先安装wvdial，然后编辑一个/etc/wvdial.conf,内容如下：
   
   [Dialer Defaults]
   Modem = /dev/ttyUSB0
   ISDN = off
   Modem Type = USB Modem
   Baud = 460800
   Init = ATX0
   Phone = #777
   Dial Prefix =
   Dial Attempts = 1
   Dial Command = ATM1L3DT
   Ask Password = off
   Password = card
   Username = card
   Auto Reconnect = on
   Abort on Busy = off
   Carrier Check = no
   Check Def Route = on
   Abort on No Dialtone = on
   Stupid Mode = on
   Idle Seconds = 0
   Auto DNS = on
   [Dialer shh]
   Init3 = ATM0
   
   而后可以直接终端输入wvdial拨号，认证通过后会显示类似如下信息：
   --> Carrier detected. Starting PPP immediately.
   --> Starting pppd at Sun Oct 4 10:54:44 2009
   --> Pid of pppd: 2584
   --> Using interface ppp0
   --> pppd: pl??0?[06][08]P?[06][08]
   --> pppd: pl??0?[06][08]P?[06][08]
   --> pppd: pl??0?[06][08]P?[06][08]
   --> pppd: pl??0?[06][08]P?[06][08]
   --> local IP address 120.41.183.23
   --> pppd: pl??0?[06][08]P?[06][08]
   --> remote IP address 115.168.76.17
   --> pppd: pl??0?[06][08]P?[06][08]
   --> primary DNS address 218.85.157.99
   --> pppd: pl??0?[06][08]P?[06][08]
   --> secondary DNS address 218.85.152.99
   --> pppd: pl??0?[06][08]P?[06][08]
   
   编辑/etc/resolv.conf，将上面DNS address后面的两个ip写入，如下：
   #write by evlinks
   nameserver 218.85.157.99
   nameserver 218.85.152.99
   nameserver 202.102.224.68
   
   以后直接终端wvdial即可上网，断开时Ctrl+c即可。